河北拉力机厂

拉力试验机（拉力机）的力量值校正：进入计算机程序后于打开校正界面，按测试开始，取一标准重量砝码轻挂于上夹具连接座，记录计算机显示力量值，并计算与标准重量砝码之差，误差应不超出±1%。

Tensile testing machine (Instron) force value correction: enter the computer program to open the interface after correction, according to the start of the test, a standard light weight hanging on the fixture with a record of computer display power value, and calculated with the standard weight difference, error should not exceed + 1%.

HZ-1001拉力试验机

HZ-1001 tensile testing machine

拉力试验机（拉力机）的速度校正：2.1首先记录机台横担之初始位置，在控制面板上选择速度值(使用标准直钢尺量测横担行程).2.2起动机台的同时电子秒表开始计时一分钟，秒表到达时间的同时按下机台停止键，根据秒表的时间，记录横担行程值即为每分钟之速率(mm/min)，观察横担行程值与直钢尺之差，并计算横担行程误差值，应不超出±1%.

Tensile testing machine (Instron) speed correction: 2.1 first recording machine crossarm initial position, select the speed value in the control panel (using standard straight ruler measurement cross arm stroke).2.2 starter and Taiwan electronic stopwatch to time a minute, stopwatch arrival time and press machine according to the stop button, the stopwatch time travel records crossarm value is the rate per minute (mm/min), to observe the cross arm stroke value and the difference of straight ruler, and calculate the horizontal stroke error value shall not exceed 1%..

拉力试验机单位转换

Unit conversion of a tensile test machine

拉力机试验机的软件曲线..能把客户的数据用曲线显示出来，同时上面也有客户的公司名称传真，这样对用户给客户看得觉得档次也有了提高.同时也可到出ES表格里面同时单位有多种选择，比如：N，KN.G，KG，LB，W，KW

The tensile testing machine software curve. To the customer's data are displayed with the curve, at the same time it also has customer company name fax, so that the user to see the customer think grades have improved. At the same time, but also to the ES table and units have a variety of options, such as: N, KN.G, KG. LB, W, KW